Audi 100

1982-1990 of release

Repair and car operation

7.4.5.1. Removal and transmission installation

THE GENERAL DATA

Automatic transmission of type 087

1 – a returnable spring; 2 – an arm; 3 – the plug; 4 – a bolt; 5 – an arm; 6 – draught; 7 – a rope; 8 – an arm;

9 – the draught lever; 10 – draught; 11 – a tip; 12 – the lever throttle заслонки; 13 – the carburettor; 14 – an accelerator pedal; 15 – the terminator; 16 – the lever

Automatic transmission of type 089

1 – an arm; 2 – contact колодка; 3 – a nut; 4 – a bolt; 5 – the plug; 6 – a bolt; 7 – the plug; 8 – the holder of a cartridge of a lamp of illumination; 9 – the screw; 10 – the contact bridge;

11 – the selector lever; 12 – a spring; 13 – a rod; 14 – a console arm; 15 – the screw; 16 – a protective cover; 17 – the handle of the lever of the selector; 18 – the screw; 19 – the console

Removal

PERFORMANCE ORDER

1. To disconnect a wire from "the minus" plug of the storage battery. 2. To disconnect two hoses from an oil radiator and to muffle their apertures. 3. To disconnect from a transmission a cable of a drive of a speedometer. 4. To hang out the engine. 5. To remove a starter (subsection 12.1.4.1 see). 6. To turn on serially bolts of fastening of the hydrotransformer to a flywheel through apertures for a starter, scrolling a cranked shaft. 7. To turn away bolts of fastening of internal SHRUS of semiaxes. 8. To remove a reception pipe of mufflers with an arm. 9. To disconnect a returnable spring 1. 10. To disconnect draught of 6 managements throttle заслонкой from a transmission. 11. To disconnect a cable of a gear change from the transmission lever. 12. To remove маслосливную a tube, having substituted preliminary under a transmission capacity for merged oil. 13. To turn away a nut of fastening of a transmission to a forward suspension bracket 14. To raise it is a little transmission. 15. To turn away the bottom bolts of fastening of a transmission to the engine. 16. To remove a transmission, watching that the hydrotransformer has not dropped out from картера couplings. 17. To fix the hydrotransformer in картере couplings.

Installation

PERFORMANCE ORDER

1. To establish a transmission, watching that the hydrotransformer remained on the seats in картере couplings. Correctness of installation of the hydrotransformer in картере couplings is defined in the size a which should be about 30 mm. 2. To wrap the bottom bolts of fastening of a transmission to the engine. 3. To establish support of fastening of a transmission to a beam of a forward suspension bracket. 4. To establish маслоналивную a transmission tube. 5. To connect a gear change cable to the transmission lever. 6. To establish draught of management throttle заслонкой. 7. To establish a returnable spring. 8. To establish a reception pipe of mufflers with an arm. 9. To connect drives of forward wheels. 10. To wrap serially bolts of fastening of the hydrotransformer to a flywheel through apertures for a starter, scrolling a cranked shaft. 11. To establish a starter. 12. To connect a cable of a drive of a speedometer. 13. To connect hoses to an oil radiator. 14. To add cooling liquid to demanded level. 15. To fill in oil in a transmission.