Audi 100

1982-1990 of release

Repair and car operation

7.2. A mechanical drive of deenergizing of coupling

7.2.1. Replacement of the bearing of deenergizing of coupling

THE GENERAL DATA

Coupling with a mechanical drive

1 – a conducted disk; 2 – press a disk in gathering; 3 – the plug; 4 – a bolt; 5 – the bearing of deenergizing of coupling; 6 – the directing plug; 7 – the lever of a plug of deenergizing of coupling; 8 – a bolt;

9 – a returnable spring; 10 – a plug of deenergizing of coupling; 11 – the adjusting plug; 12 – a counternut; 13 – a cable cover; 14 – a coupling pedal; 15 – a spring clamp

Installation of the lever of a plug of deenergizing of coupling

1 – the lever of a plug of deenergizing of coupling; 2 – the persistent plug of a cable

PERFORMANCE ORDER

1. To remove a transmission. 2. To remove by means of a screw-driver spring clamps from both parties of a holder of the bearing of deenergizing of coupling. 3. To remove the bearing of deenergizing of coupling from the directing plug. 4. To take out the bearing of deenergizing of coupling from a holder, having removed preliminary fixing скобы. 5. To establish in a holder the new bearing of deenergizing of coupling and to fix among themselves both parts of a holder fixing скобами. 6. To establish the bearing of deenergizing of coupling in gathering with a holder on directing plug. 7. To fix the bearing on a plug of deenergizing of coupling, having established two spring clamps. 8. To check up working capacity of a returnable spring. The plug of deenergizing of coupling under its influence should move the bearing aside картера transmissions. 9. To check up distance from the lever of a plug of deenergizing of coupling to the persistent plug of a cable of a drive of coupling. It should be 185 mm. Thus the coupling pedal should be released. If this distance differs from specified, it is necessary to rearrange the lever on шлицах a shaft of deenergizing of coupling.