Audi 100

1982-1990 of release

Repair and car operation

7.5. A drive of forward wheels

7.5.1. Полуось

THE GENERAL DATA

Drive of a forward wheel

1 – a nut; 2 – полуось; 3 – a lock plate;

4 – a bolt; 5 – a washer; 6 – a cover

Model	Length of a semiaxis
	The right	The left
With 4-cylinder engines:
– With mechanical КП	579,20	540,70
– With automatic КП	540,70	590,50
With 5-cylinder engines:
– With mechanical КП	550,90	550,90
– With automatic КП	529,10	582,80

Removal

PERFORMANCE ORDER

1. To brake the car a lay brake and to establish an emphasis under back wheels. 2. To weaken an inhaling of bolts of fastening of a forward wheel and to turn away a nut of 1 fastening of a semiaxis. 3. To raise and establish on a support a forward part of the car. 4. Definitively to turn away bolts of fastening and to remove a forward wheel. 5. On models with an automatic transmission to remove holders of pillows of the stabilizer of cross-section stability and to disconnect the stabilizer from a rotary fist. 6. To turn away bolts of 4 fastenings of an internal SHRUS to a flange of a semiaxis and to take out them with lock plates 3. 7. To shift полуось upwards, having disconnected it from a semiaxis flange. 8. To turn a steering wheel against the stop to the left at dismantle of the left semiaxis or to the right at dismantle of the right semiaxis. 9. Выпрессовать from a wheel nave шлицевую a part of a semiaxis by means of a stripper and to remove полуось from the car.

Installation

PERFORMANCE ORDER

1. To clear of a dirt and the rests of special glue шлицы naves and semiaxes and to wipe their gasoline. 2. To put special glue D6 on шлицы to a semiaxis (only on models of release till January, 1988 and on models with an automatic box) for the length of 5-6 mm from an end face шлицевой to a part. After that the trial trip can be made only through 60 mines to allow to glue to harden. 3. To insert полуось into a wheel nave. 4. To connect полуось to a flange and to wrap bolts of fastening М10 with lock plates the moment 80 Н·м (8,0 кгс·м) or М8 – the moment 45 Н·м (4,5 кгс·м). 5. On models with an automatic transmission to connect the stabilizer of cross-section stability. 6. To establish a wheel and наживить fastening bolts. 7. Наживить a new nut of fastening of a nave (on models of release after January, 1988 – a special bolt). 8. To lower the car on wheels. 9. To tighten a nut the moment 280 Н·м (28,0 кгс·м). On models of release after January, 1988 to tighten a special bolt the moment 200 Н·м (20,0 кгс·м), and then to tighten on a turn quarter (90 °). 10. To tighten bolts of fastening of a wheel in regular intervals the moment 110 Н·м (11,0 кгс·м).