Audi 100

1982-1990 of release

Repair and car operation




Audi 100
+ 1.1. Controls and devices
+ 2. Technical characteristics
+ 3. Engines
+ 4. Cooling system
+ 5. An exhaust system
+ 6. The power supply system
- 7. Transmission
   + 7.1. Coupling
   + 7.2. A mechanical drive of deenergizing of coupling
   + 7.3. A hydraulic drive
   - 7.4. A transmission
      - 7.4.1. Type 014 four-speed transmission
         7.4.1.1. Removal and dismantling
         7.4.1.2. Dismantling and assemblage of a primary shaft
         7.4.1.3. Dismantling and assemblage of a secondary shaft
         7.4.1.4. Assemblage and synchronizer dismantling
         7.4.1.5. Dismantling and differential assemblage
         7.4.1.6. Transmission assemblage
         7.4.1.7. Selection of a thickness of adjusting rings of back bearings
         7.4.1.8. The gear change lever
         7.4.1.9. Adjustment and installation of the mechanism of management by a gear change
      + 7.4.2. A five-speed transmission of type 013 or 093
      + 7.4.3. A five-speed transmission of types 016 and 012
      + 7.4.4. The mechanism of management of gear change КП of type 016
      + 7.4.5. An automatic transmission
   + 7.5. A drive of forward wheels
+ 8. A running gear
+ 9. A steering
+ 10. Brake system
+ 11. A body
+ 12. An electric equipment


top rated canadian pharmacies online eb52c3b6








7.4.1.7. Selection of a thickness of adjusting rings of back bearings
THE GENERAL DATA

The scheme of selection of adjusting rings at installation of back bearings of primary and secondary shaft

PERFORMANCE ORDER
1. To measure distance and from привалочной planes картера transmissions to a back end face of an external ring of the back bearing of a primary shaft.
2. To measure distance b from привалочной planes картера transmissions to a back end face of an external ring of the back bearing of a secondary shaft.
3. To measure distance c from привалочной planes of a cover to an end face of a nest of the back bearing of a secondary shaft.
4. To measure distance d from привалочной planes of a cover to an end face of a nest of the back bearing of a primary shaft.
5. For maintenance of a pretightness of bearings of 0,1 mm to calculate a thickness of adjusting rings under formulas:
    – For the bearing of a primary shaft:
S1 = d – a + T – 0,1,
Where T – the thickness of a lining equal of 0,4 mm;
    – For the bearing of a secondary shaft:
S2 = c – b + T – 0,1,
Where T – the thickness of a lining equal of 0,4 mm.
6. To pick up adjusting rings in the thickness equal S1 and S2. In spare parts adjusting washers 1,53 are delivered in the thickness; 1,58; 1,63 and 1,68 mm for the back bearing of a primary shaft and thickness from 0,15 to 1,40 mm with an interval through each 0,5 mm for the back bearing of a secondary shaft.