Audi 100

1982-1990 of release

Repair and car operation




Audi 100
- 1.1. Controls and devices
   + 1.1.1. Models of release till January 1988 г
   + 1.1.2. Models of release since January 1988 г
   1.2. window raiser with the electric drive
   1.3. An external rear-view mirror with the electric drive
   1.4. An internal rear-view mirror
   1.5. A cowl
   1.6. Forward seats with mechanical adjustment
   1.7. Forward seats with the electric drive
   1.8. Transportation of lengthy subjects
   + 1.9. Engine start
   1.10. Safety measures at an engine stop
   1.11. Cruise-control
   1.12. Heating and ventilation
   1.13. The control panel the conditioner
   1.14. The onboard computer
   1.15. Management of the onboard computer on models of release till January, 1988
   1.16. Blocking of the internal handle of the lock of a back door
   1.17. Обкатка the car
   1.18. Car check before departure
   1.19. Replacement of operational liquids and lubricants
   + 1.20. Servicing of cars of release till August, 1985
   + 1.21. Servicing of cars of release since August, 1985
   1.22. Periodicity of greasing of knots of the car
+ 2. Technical characteristics
+ 3. Engines
+ 4. Cooling system
+ 5. An exhaust system
+ 6. The power supply system
+ 7. Transmission
+ 8. A running gear
+ 9. A steering
+ 10. Brake system
+ 11. A body
+ 12. An electric equipment




eb52c3b6

1.17. Обкатка the car
THE GENERAL DATA

During the period обкатки (the first 1500 km of operation) occurs intensive extra earnings of details of the car. Therefore how the car during this period is maintained, reliability, durability and profitability of the car will depend substantially. Обкатку should pass the new car, and also the car on which the engine has been replaced or capitally repaired.

During the period обкатки it is necessary to adhere to following rules:

 – To begin movement only on the first transfer; to avoid movement on high speeds and with the maximum frequency of rotation of a cranked shaft. For this purpose it is necessary to include in due time the transfer corresponding to speed of movement; whenever possible to avoid movement in heavy road conditions (on deep snow, sand, a dirt etc.);
 – Periodically to check and if necessary to regulate a tension of belts of a drive of auxiliary units (the generator, the pump of the hydraulic booster of a steering, etc.).

It is necessary to remember that during the period обкатки belts are most intensively stretched; to watch a condition and if necessary to tighten all fixing elements of the car. The special attention needs to be turned on fastening of wheels, details of a steering, forward and back suspension brackets and a reception pipe of the muffler to a final collector of the engine.

After run of 1000 km it is necessary:

 – To check up and if necessary to adjust backlashes in a drive of valves on models with engines without hydropushers of valves;
 – To check up and if necessary to adjust frequency of rotation of a cranked shaft idling and the maintenance WITH and СН in the fulfilled gases; to replace the oil filter and oil in the engine.

After run of 1500 km it is necessary:

 – To check up and if necessary to tighten all accessible carving connections. Thus special attention to turn on fastenings of the generator, a pulley of the generator, a starter, a reception pipe of the muffler, a radiator, support of the engine, a drive of coupling, a drive of brakes, transmissions, картера couplings, wheels, details of a suspension bracket, a steering;
 – To check up and if necessary to adjust a tension of belts of a drive of auxiliary units, frequency of rotation of a cranked shaft idling and the maintenance WITH and СН in the fulfilled gases;
 – To check up a pretightness of bearings of naves of forward and back wheels, a regulator of pressure of back brakes, a convergence of forward wheels.