Audi 100

1982-1990 of release

Repair and car operation

9.3.1. A steering column with system of passive safety PROCON-TEN

THE GENERAL DATA

Column of a steering with system of passive safety "PROGAME-TEN"

1 – a shaft приводной gear wheels of the mechanism of a steering; 2 – an arm; 3 – a bolt; 4, 5 – adjusting washers; 6 – a spring; 7 – a pipe; 8 – a cable; 9 – a steering shaft; 10 – the screw; 11 – a spring ring;

12 – a flange (a steering with the hydraulic booster); 13 – the switch of ignition with the antijoy ride device; 14 – a bolt; 15 – a flange (a steering without the hydraulic booster); 16 – a collar; 17 – a bolt; 18 – a nut

Removal

PERFORMANCE ORDER

1. To disconnect a wire from "the minus" plug of the storage battery. 2. To remove a steering wheel (subsection 9.2 see). 3. To weaken fastening подрулевых switches through an aperture located from below in a casing подрулевых of switches. To remove подрулевые switches from a pipe of a steering column, having disconnected Pads with wires. 4. To turn out screws of fastening and to remove the bottom shelf from outside the driver. 5. To remove a combination of devices (subsection 12.1.5.15 see). 6. To remove воздуходув for blowing feet of the driver. 7. To disconnect a cable from a shaft of a steering column. 8. Through an aperture in the panel of a combination of devices to turn on the bolt of fastening of the case of the switch (lock) of ignition with internal шестигранником. 9. To turn away a bolt of fastening of a collar, having disconnected a shaft of a steering column from a shaft приводной gear wheels of the mechanism of a steering. On models with a steering column without the hydraulic booster preliminary to shift a protective casing. 10. To turn on two nuts and to take out two bolts of fastening of a steering column to an arm. 11. To lower an a bit steering column and to remove the case of the switch of ignition, having disconnected from it Pads with wires. 12. To take out a steering column through an aperture in the panel of devices.

Installation

PERFORMANCE ORDER

1. To establish a steering column upside-down. 2. Before connection of a shaft of a steering column with shaft приводной gear wheels of the mechanism of a steering to insert into the switch of ignition a key and to disconnect the antijoy ride device. 3. A bolt of fastening of a collar to tighten the moment 25 Н·м (2,5 кгс·м), and two bolts of fastening of a steering column – the moment 35 Н·м (3,5 кгс·м). 4. Before steering wheel installation to establish a spring with adjusting washers if they acted in film at dismantle.