Audi 100

1982-1990 of release

Repair and car operation

Audi 100
+ 1.1. Controls and devices
+ 2. Technical characteristics
+ 3. Engines
+ 4. Cooling system
+ 5. An exhaust system
+ 6. The power supply system
+ 7. Transmission
+ 8. A running gear
- 9. A steering
   9.1. A technical characteristics
   9.2. A steering wheel
   + 9.3. A steering column
   9.4. The steering mechanism
   9.5. Adjustment of the mechanism of a steering
   9.6. Steering draught
   9.7. The pump of the hydraulic booster of a steering
   9.8. Check of pressure of forcing of the pump of the hydraulic booster of a steering
   9.9. Prorolling of system of the hydraulic booster of a steering
   9.10. A privodnoj belt of the pump of the hydraulic booster
+ 10. Brake system
+ 11. A body
+ 12. An electric equipment

9.10. A privodnoj belt of the pump of the hydraulic booster
Adjustment of a tension of a belt

PERFORMANCE ORDER

Models with the 5-cylinder engine

1. To weaken an inhaling of nuts of a bolt of fastening of the pump and a bolt of an adjusting lath, and also an inhaling of a bolt of fastening of an adjusting lath.

2. To adjust a tension of a belt turn in one party of an adjusting bolt. At correctly adjusted tension the belt should cave in on 10 mm by pressing by a thumb the top branch of a belt in the middle between pulleys.

3. After adjustment to tighten all carving fastenings.

Models with the 4-cylinder engine

4. To turn away three nuts of fastening of a pulley, to remove an external half of pulley and a belt of a drive from a pulley. To take out one of the adjusting washers established between halves of a pulley, to put on a belt a pulley, to establish an external half of pulley and the removed adjusting washer on hairpins and to tighten fastening nuts.

5. To check up a belt tension. At correctly adjusted tension the belt should cave in on 10 mm by pressing by a thumb the top branch of a belt in the middle between pulleys.

6. If the tension of a belt is not enough, to rearrange the following adjusting washer. To weaken a tension of a belt, washers need to be rearranged upside-down.