Audi 100

1982-1990 of release

Repair and car operation

9.2. A steering wheel

THE GENERAL DATA

Steering column

1 – a decorative overlay; 2 – a steering wheel; 3 – a nut; 4 – a nut; 5 – колодка with wires; 6 – a washer; 7 – a spring; 8 – the bearing; 9 – подрулевые switches; 10 – a pipe; 11 – an arm of a steering column;

12 – the top shaft of a steering; 13 – the plug; 14 – the plastic plug; 15 – the bottom shaft of a column of a steering; 16 – a collar; 17, 18, 21 – bolts; 19 – an arm; 20 – the switch of ignition with the antijoy ride device

---

The prevention

On the cars completed with a pillow of safety, the steering wheel can be removed only at servicing deports.

---

Removal

PERFORMANCE ORDER

1. To disconnect a wire from "the minus" plug of the storage battery. 2. To establish forward wheels in position of movement of the car on a straight line. 3. To remove a decorative overlay and to disconnect from it колодку with wires of the switch of a sound signal. 4. To mark a relative positioning of a steering wheel and a shaft of a steering column. 5. To turn away a nut of fastening of a steering wheel on so much that its end face was заподлицо with an end face of a shaft of a steering column. 6. Shaking for spokes, with force to pull on itself a steering wheel so that it has descended with шлицев a steering shaft. To turn away definitively nut and to remove a washer and a steering wheel.

Installation

PERFORMANCE ORDER

1. Before installation to check up, that forward wheels were in position of movement of the car on a straight line and the lever of the switch of indexes of turn was in neutral position. Thus рычажок switching-off of indexes of turn should be directed to a left-hand side. 2. To establish a steering wheel on a shaft according to earlier made label. 3. To establish a washer and to wrap a nut of fastening by the moment 40 Н·м (4,0 кгс·м). 4. To insert coal contact to a wire into a steering wheel nave. 5. To connect колодку with a wire to a decorative overlay and to establish an overlay on a steering wheel. 6. To check up distance from a casing of a steering wheel to a casing подрулевых switches which should be equal 3 mm. If this distance differs from specified, to weaken fastening подрулевых switches through an aperture located from below in a casing подрулевых of switches. To expose the demanded distance and to fix подрулевые switches. 7. To make a trial trip. At car movement on direct spokes of a steering wheel should be located horizontally. Otherwise to remove a steering wheel and to establish it anew.