Audi 100

1982-1990 of release

Repair and car operation

Audi 100
+ 1.1. Controls and devices
+ 2. Technical characteristics
+ 3. Engines
+ 4. Cooling system
+ 5. An exhaust system
+ 6. The power supply system
+ 7. Transmission
+ 8. A running gear
+ 9. A steering
+ 10. Brake system
+ 11. A body
- 12. An electric equipment
   + 12.1. Electric equipment system
   - 12.2. Ignition system
      - 12.2.1. Transistor system of ignition
         12.2.1.1. Removal and installation of the distributor of ignition
         12.2.1.2. Dismantling and assemblage of the distributor of ignition
         12.2.1.3. Check and adjustment of a corner of an advancing of ignition
         12.2.1.4. Check of the coil of ignition
         12.2.1.5. Switchboard check
         12.2.1.6. Check of the gauge of the Hall
         12.2.1.7. Check of spark plugs
      + 12.2.2. Electronic system of ignition
      12.2.3. Contactless system of ignition FEI
   + 12.3. Electric schemes

12.2.1.6. Check of the gauge of the Hall

THE GENERAL DATA

The Hall gauge check at serviceable the coil of ignition and the switchboard and an ambient temperature from 0 to +40 °С.

PERFORMANCE ORDER

1. To disconnect from the ignition distributor the central high-voltage wire and to close it on "weight".

2. To pull together a rubber cover (1) with connecting Pads (2) and to connect the voltmeter to contacts «6» and «3» (3 – the switchboard).

3. To include ignition and, slowly turning a cranked shaft, to observe of voltmeter indications. They should fluctuate from zero to 2 In (the minimum value).

4. If at rotation of a cranked shaft of the indication of the voltmeter do not change, the Hall gauge means is faulty and it is necessary to replace the ignition distributor.