Audi 100

1982-1990 of release

Repair and car operation

Audi 100
+ 1.1. Controls and devices
+ 2. Technical characteristics
+ 3. Engines
+ 4. Cooling system
+ 5. An exhaust system
+ 6. The power supply system
+ 7. Transmission
+ 8. A running gear
+ 9. A steering
+ 10. Brake system
+ 11. A body
- 12. An electric equipment
   + 12.1. Electric equipment system
   - 12.2. Ignition system
      - 12.2.1. Transistor system of ignition Removal and installation of the distributor of ignition Dismantling and assemblage of the distributor of ignition Check and adjustment of a corner of an advancing of ignition Check of the coil of ignition Switchboard check Check of the gauge of the Hall Check of spark plugs
      + 12.2.2. Electronic system of ignition
      12.2.3. Contactless system of ignition FEI
   + 12.3. Electric schemes

eb52c3b6 Dismantling and assemblage of the distributor of ignition
1. To remove the distributor (subsection see).
2. To unfasten two springs and to uncover.
3. To remove бегунок.
4. To remove the antidust screen.
5. To note position of an anchor concerning the distributor platen, to remove an anchor and an adjusting pin.
6. To turn out screws and to remove vacuum-proof-reader.
7. To turn out the screw and to remove the gauge of the Hall with a nest Pads.
8. To turn out screws and to remove a motionless plate with a lining.
9. After dismantling to clear all details and knots of a dust and a dirt.
10. To examine a cover from within. If there are cracks or have burnt out contacts, it is necessary to replace a cover. To check up a condition of a contact piece of coal with a spring.
11. To create depression in the vacuum-proof-reader. Under the influence of depression draught of the vacuum-proof-reader should move. If it does not occur, the diaphragm means is torn also vacuum-proof-reader it is necessary to replace.
12. To collect the ignition distributor upside-down.