Audi 100

1982-1990 of release

Repair and car operation

Audi 100
+ 1.1. Controls and devices
+ 2. Technical characteristics
+ 3. Engines
+ 4. Cooling system
+ 5. An exhaust system
+ 6. The power supply system
+ 7. Transmission
+ 8. A running gear
+ 9. A steering
- 10. Brake system
   10.1. Technical characteristics
   10.2. Adjustment of position of a pedal of a brake
   10.3. The main cylinder of a brake
   10.4. The brake mechanism of a forward wheel of mark Teves
   10.5. The brake mechanism of a forward wheel of mark GIRLING
   10.6. A brake disk
   10.7. The case скобы and the piston
   10.8. The drum-type brake mechanism of a back wheel
   10.9. A brake drum
   10.10. The wheel brake cylinder
   10.11. The disk brake mechanism of a back wheel
   10.12. A pressure regulator
   + 10.13. A lay brake
   10.14. Antiblocking system of brakes (ABS)
   10.15. Prorolling of brake system
+ 11. A body
+ 12. An electric equipment

10.3. The main cylinder of a brake

THE GENERAL DATA

The main brake cylinder

1 – the case;

2 – the sealing plug;

3 – the union;

4 – a tank;

5 – the filter;

6 – a sealing ring;

7 – a cover;

8 – a rubber sealant;

9 – the pipeline;

10 – a bolt

Removal

PERFORMANCE ORDER

1. To disconnect a wire from "the minus" plug of the storage battery.

2. To clear of a dirt of a place of connection of pipelines to the main cylinder.

3. To disconnect wires from plugs of the gauge of level of the brake liquid established in a cover of a tank of the main cylinder and to uncover.

4. To turn away a nut of fastening and to disconnect pipelines from the case of the main cylinder of a brake. To muffle apertures of pipelines.

5. To turn away two bolts of fastening of the main cylinder to the vacuum amplifier and to remove the main cylinder of a brake with a tank. Thus to watch, that the rubber sealant of the cylinder has not dropped out.

6. To turn the main cylinder and to merge in capacity a brake liquid from a tank. Then some times to press the piston of the main cylinder, having removed thereby from it a liquid.

Installation

PERFORMANCE ORDER

The main cylinder in an order, the return to removal is established. After installation it is necessary to pump over brake system (subsection 10.15 see).