Audi 100

1982-1990 of release

Repair and car operation



Audi 100
+ 1.1. Controls and devices
+ 2. Technical characteristics
+ 3. Engines
+ 4. Cooling system
+ 5. An exhaust system
+ 6. The power supply system
+ 7. Transmission
- 8. A running gear
   + 8.1. A forward suspension bracket
   - 8.2. A back suspension bracket
      8.2.1. A telescopic rack
      8.2.2. The back bridge
      8.2.3. A brake drum
      8.2.4. A nave of a back wheel (model with the disk brake mechanism)
      8.2.5. Adjustment of bearings of a nave of a wheel
+ 9. A steering
+ 10. Brake system
+ 11. A body
+ 12. An electric equipment




eb52c3b6

8.2.5. Adjustment of bearings of a nave of a wheel
PERFORMANCE ORDER
1. To establish an emphasis under forward wheels.
2. To raise and establish on a support a back part of the car.
3. To bring down a protective cap of a nut of a nave a hammer with a rubber tip.
4. To take out шплинт and to remove a clamp of a nut of a nave.
5. To tighten a nave nut against the stop, turning thus a wheel for self-installation of bearings of a nave. Then slightly to release a nut until when the washer can be shifted by means of a screw-driver effort of a hand. Is thus inadmissible to use a screw-driver as the lever, leaning to it against a nave fillet.
6. To establish a clamp and шплинт. For aperture coincidence in a pin under шплинт and cuts in a clamp the nave nut is necessary for tightening only.
7. To add консистентную greasing in a protective cap of a nut of a nave to two thirds of its volume and запрессовать it into place by means of approaching оправки. Crushed and треснутые protective caps are subject to obligatory replacement (in avoidance of hit of a dirt and a moisture in a nave).