| 1. Запрессовать by means of corresponding оправок external rings of both bearings in a nave. Thus to pay attention that the big diameters of external rings should be directed in a nave.
| 2. To establish the internal bearing in a corresponding external ring in a nave, preliminary having greased it консистентной with greasing.
| 3. Запрессовать to a nave заподлицо with an end face an epiploon, which external edge should be directed in a nave.
|4. To put in an internal cavity of a nave консистентную greasing and to establish a nave on a pin.
|5. To establish the external bearing in a nave, preliminary having greased it консистентной with greasing.
|6. To establish an adjusting washer and to wrap a nave nut.
|7. To establish a brake disk.
|8. To establish a wheel and наживить bolts of its fastening.
|9. To adjust nave bearings (subsection 8.2.5 see).
|10. To fill a protective cap of a nut of a nave on two third консистентной with greasing and запрессовать it into place by means of approaching оправки. Crushed and треснутые protective caps are subject to obligatory replacement (in avoidance of hit of a dirt and a moisture in a nave).
|11. To lower the car on wheels and to tighten bolts of fastening of a wheel in regular intervals the moment 110 Н·м (11,0 кгс·м).