Audi 100

1982-1990 of release

Repair and car operation

Audi 100
+ 1.1. Controls and devices
+ 2. Technical characteristics
+ 3. Engines
+ 4. Cooling system
+ 5. An exhaust system
+ 6. The power supply system
+ 7. Transmission
+ 8. A running gear
+ 9. A steering
+ 10. Brake system
+ 11. A body
- 12. An electric equipment
   + 12.1. Electric equipment system
   - 12.2. Ignition system
      + 12.2.1. Transistor system of ignition
      - 12.2.2. Electronic system of ignition
         12.2.2.1. Check of the coil of ignition
         12.2.2.2. Check of the gauge of a corner of an advancing of ignition
         12.2.2.3. Check of the gauge of frequency of rotation of a cranked shaft
         12.2.2.4. The gauge of a corner of an advancing of ignition, frequency of rotation of a cranked shaft
         12.2.2.5. Check and replacement of the gauge of temperature of air
         12.2.2.6. Check of the gauge of temperature of a cooling liquid
         12.2.2.7. Switches of a mode of idling and opening throttle заслонки
         12.2.2.8. Check of the gauge of the Hall
         12.2.2.9. Check of the block of management
      12.2.3. Contactless system of ignition FEI
   + 12.3. Electric schemes

12.2.2.6. Check of the gauge of temperature of a cooling liquid

THE GENERAL DATA

To check the gauge it is necessary at temperature of a cooling liquid 20 °С.

PERFORMANCE ORDER

1. To disconnect a wire from the gauge (it is specified by an arrow).

2. To measure resistance between contact of the gauge and "weight". It should be from 60 to 1000 Ohm. If resistance differs from specified, it is necessary to replace the gauge.

3. To measure by an ohmmeter resistance between the plug on a wire and contact «10». It should be equal to zero. If the ohmmeter shows any resistance, in conducting there is a breakage and it needs to be eliminated.