Audi 100

1982-1990 of release

Repair and car operation

Audi 100
+ 1.1. Controls and devices
+ 2. Technical characteristics
+ 3. Engines
+ 4. Cooling system
+ 5. An exhaust system
- 6. The power supply system
   - 6.1. The power supply system of carburettor engines
      6.1.1. Replacement of a filtering element of the air filter
      6.1.2. Removal and installation of the air filter
      6.1.3. Temperature regulator check
      6.1.4. Check of the valve of a temperature regulator
      6.1.5. Removal and installation of the fuel pump
      6.1.6. Check of pressure of forcing of the fuel pump
      6.1.7. Removal and installation of a cable of a drive of an accelerator
      6.1.8. Adjustment of a cable of a drive of an accelerator
      6.1.9. Replacement of the gauge of level of fuel
      6.1.10. Removal and installation of a fuel tank
      6.1.11. Replacement of the filter of thin clearing of fuel
      6.1.12. Removal and carburettor installation
      + 6.1.13. Dismantling and carburettor assemblage
      - 6.1.14. Carburettor Pierburg adjustments 1B3
         6.1.14.1. Adjustment of frequency of rotation of start-up of the engine
         6.1.14.2. Adjustment of starting backlashes air заслонки
         6.1.14.3. Adjustment приоткрывания throttle заслонки
         6.1.14.4. Adjustment of the accelerating pump
         6.1.14.5. Idling adjustment
      + 6.1.15. Carburettor Pierburg adjustments 2Е2
      + 6.1.16. Carburettor Keihin adjustments
   + 6.2. The power supply system of engines with fuel injection
   + 6.3. The power supply system of the diesel engine
+ 7. Transmission
+ 8. A running gear
+ 9. A steering
+ 10. Brake system
+ 11. A body
+ 12. An electric equipment

6.1.14.5. Idling adjustment

THE GENERAL DATA

Adjustment spend on the heated-up engine with the adjusted backlashes in the mechanism of a drive of valves and the ignition moment.

PERFORMANCE ORDER

1. To connect to the engine a control tachometre and a gas analyzer according to the manufacturer instruction.

2. The adjusting screw of quantity of a mix (it is specified by an arrow) to establish frequency of rotation of a cranked shaft in limits (750±50) mines-¹.

3. The adjusting screw of quality (structure) of a mix (it is specified by an arrow) to establish maintenance level oxide carbon (WITH) in the fulfilled gases no more than 1,0 (±0,5) %. To check up and if necessary to adjust frequency of rotation of idling, and then once again the maintenance WITH in the fulfilled gases.