Audi 100

1982-1990 of release

Repair and car operation




Audi 100
+ 1.1. Controls and devices
+ 2. Technical characteristics
+ 3. Engines
+ 4. Cooling system
+ 5. An exhaust system
- 6. The power supply system
   - 6.1. The power supply system of carburettor engines
      6.1.1. Replacement of a filtering element of the air filter
      6.1.2. Removal and installation of the air filter
      6.1.3. Temperature regulator check
      6.1.4. Check of the valve of a temperature regulator
      6.1.5. Removal and installation of the fuel pump
      6.1.6. Check of pressure of forcing of the fuel pump
      6.1.7. Removal and installation of a cable of a drive of an accelerator
      6.1.8. Adjustment of a cable of a drive of an accelerator
      6.1.9. Replacement of the gauge of level of fuel
      6.1.10. Removal and installation of a fuel tank
      6.1.11. Replacement of the filter of thin clearing of fuel
      6.1.12. Removal and carburettor installation
      + 6.1.13. Dismantling and carburettor assemblage
      - 6.1.14. Carburettor Pierburg adjustments 1B3
         6.1.14.1. Adjustment of frequency of rotation of start-up of the engine
         6.1.14.2. Adjustment of starting backlashes air заслонки
         6.1.14.3. Adjustment приоткрывания throttle заслонки
         6.1.14.4. Adjustment of the accelerating pump
         6.1.14.5. Idling adjustment
      + 6.1.15. Carburettor Pierburg adjustments 2Е2
      + 6.1.16. Carburettor Keihin adjustments
   + 6.2. The power supply system of engines with fuel injection
   + 6.3. The power supply system of the diesel engine
+ 7. Transmission
+ 8. A running gear
+ 9. A steering
+ 10. Brake system
+ 11. A body
+ 12. An electric equipment




eb52c3b6

6.1.14.4. Adjustment of the accelerating pump
PERFORMANCE ORDER
1. To remove the carburettor.
2. To fill поплавковую the chamber with fuel and to put under the carburettor a measured beaker with a funnel.
3. To take away the lever (2) from the screw (1).
4. To turn throttle заслонку from an emphasis against the stop ten times, spending for each course approximately 3 with, putting it in action the accelerating pump.
5. To measure quantity of fuel in a beaker, the received value to divide into ten. The result is pump giving for one cycle. For one cycle the accelerating pump should submit (0,9±0,15) fuel sm3.
6. If the received result differs from specified, to adjust productivity of the accelerating pump, turning a cam (1), preliminary having weakened the screw (2).
7. After adjustment to tighten the screw.