Audi 100

1982-1990 of release

Repair and car operation

Audi 100
+ 1.1. Controls and devices
+ 2. Technical characteristics
- 3. Engines
   + 3.1. Four-cylinder engines
   - 3.2. Five-cylinder engines
      3.2.1. Removal and engine installation
      - 3.2.2. Dismantling and engine assemblage
         3.2.2.1. Removal and installation of a head of the block of cylinders
         3.2.2.2. Adjustment and a tension of a belt of a drive of a camshaft
         3.2.2.3. Survey, дефектовка and repair of details of a head of the block
         3.2.2.4. Removal of a camshaft and pushers of valves
         3.2.2.5. Installation of a camshaft and pushers of valves
         3.2.2.6. Removal and installation of valves
         3.2.2.7. Dismantling and assemblage of a drive of a camshaft
         3.2.2.8. Removal and flywheel installation
         3.2.2.9. Removal and installation oil картера
         3.2.2.10. Removal, check and installation of the oil pump
         3.2.2.11. Replacement of epiploons of a cranked shaft
         3.2.2.12. A cranked shaft and shatunno-piston group
   + 3.3. The diesel engine
+ 4. Cooling system
+ 5. An exhaust system
+ 6. The power supply system
+ 7. Transmission
+ 8. A running gear
+ 9. A steering
+ 10. Brake system
+ 11. A body
+ 12. An electric equipment

3.2.2.8. Removal and flywheel installation

THE GENERAL DATA

Flywheel, cranked shaft, the oil pump

1 – the oil pump;
2 – a lining of the oil pump;
3 – the block of cylinders;
4 – a lining of the holder of an epiploon;
5 – the holder of an epiploon;
6 – an epiploon back a cranked shaft;
7 – a flywheel;
8 – the bearing of a primary shaft of a transmission;
9 – the bottom loose leaf of the radical bearing;
10 – a cover of the radical bearing;
11 – a bolt of fastening of a cover of the radical bearing;
12 – the receiver of the oil pump;
13 – a receiver lining;
14 – a cranked shaft;
15 – the top loose leaf of the radical bearing;
16 – a forward epiploon of a cranked shaft;
17 – a rack of fastening of the top cover of a drive of a camshaft

On cars with automatic transmission instead of a flywheel it is established приводной a disk. A removal and installation order drive a disk same, as for a flywheel.

PERFORMANCE ORDER

1. To mark mutual position of a flywheel and a cranked shaft.

2. In regular intervals to turn away bolts of fastening of a flywheel on 1–2 turns.

3. Gradually in regular intervals to turn out bolts of fastening of a flywheel and to remove a flywheel 7.

4. To establish a flywheel (приводной a disk) upside-down. Before installation to put on a carving of bolts of fastening of a flywheel hermetic. Bolts to tighten the moment 100 Н·м (10 кгс·м). If приводной a disk replaced new, to check up and if it is necessary to adjust its position. The distance from a back wall of the block of cylinders to an adjusting surface of the transformer on приводном a disk should be 17,2–18,8 mm. To adjust position drive a disk it is possible, having established between it and cranked shaft a lining.