Audi 100

1982-1990 of release

Repair and car operation




Audi 100
+ 1.1. Controls and devices
+ 2. Technical characteristics
+ 3. Engines
+ 4. Cooling system
+ 5. An exhaust system
- 6. The power supply system
   + 6.1. The power supply system of carburettor engines
   - 6.2. The power supply system of engines with fuel injection
      6.2.1. Replacement of a filtering element of the air filter
      6.2.2. Removal and installation of the air filter
      6.2.3. Replacement of the fuel filter
      6.2.4. Removal and installation of the distributor of fuel
      6.2.5. Dismantling and assemblage редукционного the valve
      6.2.6. Removal and installation of the fuel accumulator
      6.2.7. Removal and installation of fuel atomizers
      6.2.8. Removal and installation турбокомпрессора
      6.2.9. Removal and installation of a fuel tank
      6.2.10. Removal and installation of the fuel pump
      6.2.11. Temperature regulator check
      6.2.12. Adjustment of idling of the engine
      6.2.13. Check of a starting atomizer
      6.2.14. Check of a regulator of pressure
      6.2.15. Check and adjustment of position of a plate of a measuring instrument of the expense of air
   + 6.3. The power supply system of the diesel engine
+ 7. Transmission
+ 8. A running gear
+ 9. A steering
+ 10. Brake system
+ 11. A body
+ 12. An electric equipment




eb52c3b6

6.2.13. Check of a starting atomizer
THE GENERAL DATA

Check a starting atomizer (Basic elements of system of injection of fuel) fig. see the cold engine (temperature of a cooling liquid more low 30 °) at completely charged accumulator.

PERFORMANCE ORDER
1. To disconnect the central wire from the distributor of ignition and to close it on "weight".
2. To turn away bolts of fastening and to disconnect топливопроводы from a regulator and an atomizer.
3. To turn away two bolts and to remove an atomizer and a lining from an inlet pipe of the engine.
4. To connect to an atomizer топливопровод. To include a starter on 10 with. The atomizer should spray fuel in the form of a cone during time of start of the engine. If the given conditions are not carried out, to replace an atomizer.
5. To establish an atomizer upside-down, having replaced a lining.