Audi 100

1982-1990 of release

Repair and car operation




Audi 100
+ 1.1. Controls and devices
+ 2. Technical characteristics
- 3. Engines
   - 3.1. Four-cylinder engines
      3.1.1. Removal and engine installation
      + 3.1.2. Dismantling and engine assemblage
   + 3.2. Five-cylinder engines
   + 3.3. The diesel engine
+ 4. Cooling system
+ 5. An exhaust system
+ 6. The power supply system
+ 7. Transmission
+ 8. A running gear
+ 9. A steering
+ 10. Brake system
+ 11. A body
+ 12. An electric equipment




eb52c3b6

3.1.1. Removal and engine installation
PERFORMANCE ORDER
1. To establish the car over a viewing ditch so that the engine there were under талью or other similar device load-carrying capacity not less than 300 kg.
2. To disconnect a wire from "the minus" plug of the storage battery located in a water-proof casing on the right (on the cars equipped with the conditioner, the storage battery is located under a back seat).
3. To remove a cowl (cм. Subsection 11.3 subitem 1-6).
4. To disconnect from the thermostat case taking away hose of a radiator, to remove a stopper from a broad tank and to merge cooling liquid (subsection 4.1 subitem 1-3 see).
5. To turn away drain stoppers in картере the engine and картере transmissions and to merge oil.
6. To turn away drain stoppers in картере the engine and картере transmissions and to merge oil.
7. To disconnect electric wires from the gauge of inclusion of the electrofan and from the fan of system of cooling.
8. To remove a radiator (subsection 4.6 subitem 3-9 see).
9. To disconnect from the fuel pump hoses of giving and the return fuel plum (cм. Subsection 6.1.5 item 2).
10. To disconnect wires from knots and the elements of an electric equipment established on the engine.
11. To disconnect from the carburettor vacuum hoses and management cables.
12. To remove the air filter (cм. Subsection 6.1.2 subitem 1-6).
13. On cars with the conditioner to remove the compressor, without disconnecting hoses, and to fix its wire on a body.
14. On cars with the steering hydraulic booster to remove the pump, without disconnecting hoses, and to fix its wire on a body.
15. To remove теплоизоляционный a guard of the right support of the engine.
16. To disconnect a reception pipe of the muffler from a flange of a final collector (cм. Subsection 5.1 item 1).
17. Slightly to weaken an inhaling of a nut of fastening of the right arm of an engine mount.
18. To remove a starter (cм. Subsection 12.1.4.1 subitem 1-3).
19. To disconnect a reception pipe of the muffler from a transmission arm.
20. To turn out the bottom bolts of fastening of a transmission to the engine.
21. To turn away bolts of fastening and to remove the bottom part картера couplings.
22. Slightly to weaken an inhaling of a nut of fastening of the left arm of an engine mount.
23. On cars with an automatic transmission to turn on bolts of fastening of the hydrotransformer.
24. To substitute under a transmission a jack or other suitable support.
25. To turn away bolts of fastening of a transmission to the engine.
26. To disconnect a wire of "weight" of the engine.
27. To check up, whether all hoses and electricity cables are disconnected from the engine.
28. To turn away a nut of fastening of the left and right arms of the engine and to hang out the engine with the help тали.
29. To remove engine mount arms.
30. To take out the engine from a motor compartment. On cars with automatic transmission to fix the hydrotransformer in картере couplings that it has not dropped out.
31. To establish the engine upside-down. On cars with a mechanical transmission before engine installation to grease with a thin layer консистентной greasings шлицы a primary shaft of a transmission.