Audi 100

1982-1990 of release

Repair and car operation

Audi 100
+ 1.1. Controls and devices
+ 2. Technical characteristics
+ 3. Engines
+ 4. Cooling system
+ 5. An exhaust system
+ 6. The power supply system
+ 7. Transmission
+ 8. A running gear
+ 9. A steering
+ 10. Brake system
+ 11. A body
- 12. An electric equipment
   - 12.1. Electric equipment system
      12.1.1. A technical characteristics
      12.1.2. Safety locks, the relay and management blocks
      + 12.1.3. The generator
      - 12.1.4. A starter Removal and starter installation Dismantling and starter assemblage Check, survey and дефектовка starter details
      + 12.1.5. Illumination and the light alarm system
   + 12.2. Ignition system
   + 12.3. Electric schemes

eb52c3b6 Dismantling and starter assemblage
1. To turn away a nut.
2. To remove a basic plate.
3. To turn out two винтаи to uncover with a lining.
4. To remove a lock ring with washers.
5. To turn away coupling bolts.
6. To uncover from outside a collector.
7. To turn away a nut and to disconnect a winding conclusion статора from the traction relay.
8. To take out щеткодержатель from the case, thus to wring out springs and to take out two isolated brushes from щеткодержателя.
9. To remove the case.
10. To turn away three bolts and to remove the traction relay from a cover. Thus the anchor of the traction relay should remain on the drive lever.
11. To take out a rubber sealant of the lever. To remove from the lever an anchor of the traction relay.
12. To turn out a lever axis.
13. To take out an anchor from a cover from outside a drive. To remove the drive lever.
14. To bring down through оправку keeping ring towards an anchor. To remove the lock ring established under the keeping ring.
15. To remove from a shaft of an anchor a starter drive in gathering.
16. At starter Bosch 1,1kW to remove a reducer. To collect a starter upside-down, thus it is necessary to establish a new lock ring, and also to grease rubbing surfaces of details.